Experimental dlPFC then dmPFC then Sham iTBS
|
|
-
Device: TMS to dmPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dmPFC, approximately 25% of the
nasion-inion distance or Talairah coordinates X 0 Y+60 Z+60 will be measured. The first
session will begin with the acquisition of the resting motor threshold (rMT) on the
contralateral hand. iTBS (triplet 50 Hz bursts, repeated at 5 Hz, 2 sec on and 8 sec off;
600 pulses per session) will be delivered at 110% of the rMT and will last ~3 minutes.
The stimulation will start at a lower percentage and ramp up over time to acclimate
participant to the feeling of stimulation. The intensity will be lowered in participant
cannot tolerate the stimulation. Each participant will receive 3 sessions per visit with
a 15-20 minute interval between sessions to increase the likelihood of detecting acute
effects.
-
Device: TMS to dlPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dlPFC, position F3 will be measured,
using probabilistic EEG placement. The first session will begin with the acquisition of
the resting motor threshold on the contralateral hand. iTBS (triplet 50 Hz bursts,
repeated at 5 Hz, 2 sec on and 8 sec off; 600 pulses per session) will be delivered at
110% of the rMT and will last 3 minutes. The stimulation will start at a lower percentage
and ramp up over time to acclimate participant to the feeling of stimulation. The
intensity will be lowered in participant cannot tolerate the stimulation. Each
participant will receive 3 sessions per visit with a 15-20 minute interval between
sessions to increase the likelihood of detecting acute effects.
-
Device: Sham iTBS
Sham TMS will be delivered with the sham side of the MagVenture Cool B70 A/P coil. The
software will be pre-programmed by a staff member that will not be involved in data
analysis or collection for blinding purposes. The sham stimulation will match the number
of pulses and length of time as the active condition and each participant will receive 3
sessions with a 15-20 min interval between sessions.
|
Experimental dmPFC then dlPFC then sham iTBS
|
|
-
Device: TMS to dmPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dmPFC, approximately 25% of the
nasion-inion distance or Talairah coordinates X 0 Y+60 Z+60 will be measured. The first
session will begin with the acquisition of the resting motor threshold (rMT) on the
contralateral hand. iTBS (triplet 50 Hz bursts, repeated at 5 Hz, 2 sec on and 8 sec off;
600 pulses per session) will be delivered at 110% of the rMT and will last ~3 minutes.
The stimulation will start at a lower percentage and ramp up over time to acclimate
participant to the feeling of stimulation. The intensity will be lowered in participant
cannot tolerate the stimulation. Each participant will receive 3 sessions per visit with
a 15-20 minute interval between sessions to increase the likelihood of detecting acute
effects.
-
Device: TMS to dlPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dlPFC, position F3 will be measured,
using probabilistic EEG placement. The first session will begin with the acquisition of
the resting motor threshold on the contralateral hand. iTBS (triplet 50 Hz bursts,
repeated at 5 Hz, 2 sec on and 8 sec off; 600 pulses per session) will be delivered at
110% of the rMT and will last 3 minutes. The stimulation will start at a lower percentage
and ramp up over time to acclimate participant to the feeling of stimulation. The
intensity will be lowered in participant cannot tolerate the stimulation. Each
participant will receive 3 sessions per visit with a 15-20 minute interval between
sessions to increase the likelihood of detecting acute effects.
-
Device: Sham iTBS
Sham TMS will be delivered with the sham side of the MagVenture Cool B70 A/P coil. The
software will be pre-programmed by a staff member that will not be involved in data
analysis or collection for blinding purposes. The sham stimulation will match the number
of pulses and length of time as the active condition and each participant will receive 3
sessions with a 15-20 min interval between sessions.
|
Experimental dmPFC then sham iTBS then dlPFC
|
|
-
Device: TMS to dmPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dmPFC, approximately 25% of the
nasion-inion distance or Talairah coordinates X 0 Y+60 Z+60 will be measured. The first
session will begin with the acquisition of the resting motor threshold (rMT) on the
contralateral hand. iTBS (triplet 50 Hz bursts, repeated at 5 Hz, 2 sec on and 8 sec off;
600 pulses per session) will be delivered at 110% of the rMT and will last ~3 minutes.
The stimulation will start at a lower percentage and ramp up over time to acclimate
participant to the feeling of stimulation. The intensity will be lowered in participant
cannot tolerate the stimulation. Each participant will receive 3 sessions per visit with
a 15-20 minute interval between sessions to increase the likelihood of detecting acute
effects.
-
Device: TMS to dlPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dlPFC, position F3 will be measured,
using probabilistic EEG placement. The first session will begin with the acquisition of
the resting motor threshold on the contralateral hand. iTBS (triplet 50 Hz bursts,
repeated at 5 Hz, 2 sec on and 8 sec off; 600 pulses per session) will be delivered at
110% of the rMT and will last 3 minutes. The stimulation will start at a lower percentage
and ramp up over time to acclimate participant to the feeling of stimulation. The
intensity will be lowered in participant cannot tolerate the stimulation. Each
participant will receive 3 sessions per visit with a 15-20 minute interval between
sessions to increase the likelihood of detecting acute effects.
-
Device: Sham iTBS
Sham TMS will be delivered with the sham side of the MagVenture Cool B70 A/P coil. The
software will be pre-programmed by a staff member that will not be involved in data
analysis or collection for blinding purposes. The sham stimulation will match the number
of pulses and length of time as the active condition and each participant will receive 3
sessions with a 15-20 min interval between sessions.
|
Experimental dlPFC then sham iTBS then dmPFC
|
|
-
Device: TMS to dmPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dmPFC, approximately 25% of the
nasion-inion distance or Talairah coordinates X 0 Y+60 Z+60 will be measured. The first
session will begin with the acquisition of the resting motor threshold (rMT) on the
contralateral hand. iTBS (triplet 50 Hz bursts, repeated at 5 Hz, 2 sec on and 8 sec off;
600 pulses per session) will be delivered at 110% of the rMT and will last ~3 minutes.
The stimulation will start at a lower percentage and ramp up over time to acclimate
participant to the feeling of stimulation. The intensity will be lowered in participant
cannot tolerate the stimulation. Each participant will receive 3 sessions per visit with
a 15-20 minute interval between sessions to increase the likelihood of detecting acute
effects.
-
Device: TMS to dlPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dlPFC, position F3 will be measured,
using probabilistic EEG placement. The first session will begin with the acquisition of
the resting motor threshold on the contralateral hand. iTBS (triplet 50 Hz bursts,
repeated at 5 Hz, 2 sec on and 8 sec off; 600 pulses per session) will be delivered at
110% of the rMT and will last 3 minutes. The stimulation will start at a lower percentage
and ramp up over time to acclimate participant to the feeling of stimulation. The
intensity will be lowered in participant cannot tolerate the stimulation. Each
participant will receive 3 sessions per visit with a 15-20 minute interval between
sessions to increase the likelihood of detecting acute effects.
-
Device: Sham iTBS
Sham TMS will be delivered with the sham side of the MagVenture Cool B70 A/P coil. The
software will be pre-programmed by a staff member that will not be involved in data
analysis or collection for blinding purposes. The sham stimulation will match the number
of pulses and length of time as the active condition and each participant will receive 3
sessions with a 15-20 min interval between sessions.
|
Experimental sham iTBS then dlPFC then dmPFC
|
|
-
Device: TMS to dmPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dmPFC, approximately 25% of the
nasion-inion distance or Talairah coordinates X 0 Y+60 Z+60 will be measured. The first
session will begin with the acquisition of the resting motor threshold (rMT) on the
contralateral hand. iTBS (triplet 50 Hz bursts, repeated at 5 Hz, 2 sec on and 8 sec off;
600 pulses per session) will be delivered at 110% of the rMT and will last ~3 minutes.
The stimulation will start at a lower percentage and ramp up over time to acclimate
participant to the feeling of stimulation. The intensity will be lowered in participant
cannot tolerate the stimulation. Each participant will receive 3 sessions per visit with
a 15-20 minute interval between sessions to increase the likelihood of detecting acute
effects.
-
Device: TMS to dlPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dlPFC, position F3 will be measured,
using probabilistic EEG placement. The first session will begin with the acquisition of
the resting motor threshold on the contralateral hand. iTBS (triplet 50 Hz bursts,
repeated at 5 Hz, 2 sec on and 8 sec off; 600 pulses per session) will be delivered at
110% of the rMT and will last 3 minutes. The stimulation will start at a lower percentage
and ramp up over time to acclimate participant to the feeling of stimulation. The
intensity will be lowered in participant cannot tolerate the stimulation. Each
participant will receive 3 sessions per visit with a 15-20 minute interval between
sessions to increase the likelihood of detecting acute effects.
-
Device: Sham iTBS
Sham TMS will be delivered with the sham side of the MagVenture Cool B70 A/P coil. The
software will be pre-programmed by a staff member that will not be involved in data
analysis or collection for blinding purposes. The sham stimulation will match the number
of pulses and length of time as the active condition and each participant will receive 3
sessions with a 15-20 min interval between sessions.
|
Experimental shami iTBS then dmPFC then dl PFC
|
|
-
Device: TMS to dmPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dmPFC, approximately 25% of the
nasion-inion distance or Talairah coordinates X 0 Y+60 Z+60 will be measured. The first
session will begin with the acquisition of the resting motor threshold (rMT) on the
contralateral hand. iTBS (triplet 50 Hz bursts, repeated at 5 Hz, 2 sec on and 8 sec off;
600 pulses per session) will be delivered at 110% of the rMT and will last ~3 minutes.
The stimulation will start at a lower percentage and ramp up over time to acclimate
participant to the feeling of stimulation. The intensity will be lowered in participant
cannot tolerate the stimulation. Each participant will receive 3 sessions per visit with
a 15-20 minute interval between sessions to increase the likelihood of detecting acute
effects.
-
Device: TMS to dlPFC
TMS will be delivered with a MagVenture Mag Pro R30 with the Cool-B70 A/P coil with
active liquid cooling and active/sham sides. For dlPFC, position F3 will be measured,
using probabilistic EEG placement. The first session will begin with the acquisition of
the resting motor threshold on the contralateral hand. iTBS (triplet 50 Hz bursts,
repeated at 5 Hz, 2 sec on and 8 sec off; 600 pulses per session) will be delivered at
110% of the rMT and will last 3 minutes. The stimulation will start at a lower percentage
and ramp up over time to acclimate participant to the feeling of stimulation. The
intensity will be lowered in participant cannot tolerate the stimulation. Each
participant will receive 3 sessions per visit with a 15-20 minute interval between
sessions to increase the likelihood of detecting acute effects.
-
Device: Sham iTBS
Sham TMS will be delivered with the sham side of the MagVenture Cool B70 A/P coil. The
software will be pre-programmed by a staff member that will not be involved in data
analysis or collection for blinding purposes. The sham stimulation will match the number
of pulses and length of time as the active condition and each participant will receive 3
sessions with a 15-20 min interval between sessions.
|